![]() Also, do not install the jumper near stairways. This is the place where the batteries need to be installed. Once you have found the piano control, then lean down so that you can see the back side of it. In most cases, the piano control is located on the side of the jumper. February 2 Stiff Little Fingers, Essential Logic, Robert Rental and the. Locate the battery compartment and undo the screws First of all, you need to locate the piano control of the jumper. Your baby may hurt him/herself if he/she does not meet these conditions.ĭo not allow children that can stand or walk on their own to use the jumper.ĭo not swing or spin your baby in the jumper.ĭo not add strings, straps, hardware or other parts to the jumper.ĭo not place the jumper on an elevated surface it must be installed on a flat surface for your baby's safety. I was just about through the door when the bouncer reappeared and threw both of. Use the activity jumper only if your baby is at least 4 months of age, can sit up by him/herself, is less than 30 inches tall and weighs less than 25 pounds. Turn the piano on by sliding the power switch in the left corner to the right choose either the piano key symbol for "Piano Mode" or the music note symbol for "Melody Mode." Play with your baby using the piano control and the attached handles. ![]() Pull the knobs located in the front of the jumper, and click them into the appropriate hole gently to set the seat's height. Place your baby gently inside the seat until the ball of his/her foot is at a slightly curved angle with the floor the position of his/her foot tells you how high the seat must be adjusted for his/her comfort. Install the three C/LR14 1.5V batteries into the compartment, and close it up with the screws and Phillips screwdriver. ![]()
0 Comments
Leave a Reply. |